Digibell Vandal Resistant System Przewodnik Instalacji Pobierz pdf (Strona 55)

Digibell Vandal Resistant System

PD-169 Issue 3B Installation Guide Page 55 of 56

Safety Information and Declarations

Connections to the 240VAC mains supply must be carried out by a qualified electrician or

similar competent person, and made in accordance with current legislative requirements. A

two pole switch (as provided by a Consumer Unit or Switch Fuse) must be included to isolate

both Live and Neutral during Installation or Maintenance. The circuit must be protected by a

fuse or other current limiting device, rated according to the capacity of the cable used, up to a

maximum of 10A. Use only mains cable to BS6004 or equivalent, within the following

specified limits:

Min Max

Conductor Diameter

1.0mm (0.8mm

)

2.25mm (4mm

)

Cable Diameter 4.0mm 8.0mm

Model 840 Power Supply (with battery standby)

The Model 840 power supply must be placed in a protected indoor environment such as an

electrical cupboard. It must be secured to the wall with adequate fixings so that there is no

possibility of it falling. The Lead acid battery for the standby power supply is shipped in

separate packaging. It should only be connected once the system has been fully tested.

Connection is made by 2 leads with spade terminals; observe the correct polarity - red to

positive, black to negative. Care must be taken to ensure that the terminals of the battery are

not shorted together by metal objects, as this may constitute a Fire Hazard. A good mains

safety earth must be connected to all sections of the enclosure.

Where the power supply is fitted with a replaceable internal mains fuse and or battery fuse,

always replace with the same type as indicated on the power supply. The fuse must be

approved to BS EN 60127 or equivalent.

Power Supply Model

Mains Fuse (Time Delay) Battery Fuse (Quick Blow)

840 T2A 20mm HBC (HRC) Ceramic

F4A 20mm Glass

Model PS4 Power Supply

These power supplies must be wall-mounted onto plasterboard, or a similar non-conductive

material, in a protected indoor environment such as an electrical cupboard. When fitting the

power supply cable (both mains and low voltage) ensure the cable entry cut-outs in the

enclosure lid are no larger than necessary for the cable diameter used and under no

circumstances must they be taken beyond the outer cut-out zones.

1 2 ... 50 51 52 53 54 55 56

Brak uwag

Digibell Vandal Resistant System Przewodnik Instalacji Strona 55