Digibell Vandal Resistant System Przewodnik Instalacji Pobierz pdf (Strona 53)

Digibell Vandal Resistant System

PD-169 Issue 3B Installation Guide Page 53 of 56

Diagram 13 – Combined System Connections

Connecting a Bell PAX1 Proximity Reader

Connect the lock release as per this manual. Leave the Proximity Reader set to fail secure,

the BSD-DIG controller sets the lock type.

Note 1. A normally open exit button can still be wired to the BSD-DIG controller in addition

to the proximity wiring.

Opening/Triggering a Gate or Locks on a Third Party System

Leave the BSD-DIG controller set to Fail secure.

Generally when connecting to a third party system the lock release should be connected as

recommended by the other manufacturer; the NO and COM connections from the 89 relay,

as shown above, should be connected to a trigger input on the third party system, often

marked RTE (request to exit). For further advice please contact your distributor.

1 2 ... 48 49 50 51 52 53 54 55 56

Brak uwag

Digibell Vandal Resistant System Przewodnik Instalacji Strona 53