Digibell Vandal Resistant System Przewodnik Instalacji Pobierz pdf (Strona 31)

Digibell Vandal Resistant System

PD-169 Issue 3B Installation Guide Page 31 of 56

Phone ring test

This test can be used to ring a phone on one of the four outputs of the DBA-4I isolator to

verify basic operation. It can be used to test the ringer, hook switch and lock button operation

but not the two way speech.

1. Press the Test button twice to ensure the system is in idle.

2. Set SW7 to test the appropriate phone (only one phone at a time):

1 ON 1

Phone

2 ON 2

Phone

3 ON 3

Phone

4 ON 4

Phone

3. Press Test to ring the phone

4. If the phone is taken off-hook the speech light will come on, and go back off when the

phone is replaced.

5. If the lock button is pressed, while the speech light is on, the status LED will come on

for 3 seconds, if using the BS-LX phone the green LED on the phone will also come

on for 3 seconds.

6. Press the test button at any time to cancel.

7. Restore SW7 to the required address setting

Diagnostic LEDs

LED

State

Action on LED

Status Power up Flashes 3 times

Data is present on Data A/B. Brief flash

Phone lock button pressed during a call or test On for 3 seconds

Test button pressed and system idle Brief flash

Restoring factory defaults On for 2 seconds

Speech Speech active (call in progress);

Ring Test active (no speech)

LED1 1

Phone active On

LED2 2

Phone active On

LED3 3

Phone active On

LED4 4

Phone active On

Fuse

The 12V connection (V terminal) to each flat/phone is individually fused with a standard

20mm fuse, which will need replacing if it fails.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Komentarze do niniejszej Instrukcji

Brak uwag

Digibell Vandal Resistant System Przewodnik Instalacji Strona 31

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Domofony Digibell Vandal Resistant System