Digibell Vandal Resistant System Przewodnik Instalacji Pobierz pdf (Strona 11)

Digibell Vandal Resistant System

PD-169 Issue 3B Installation Guide Page 11 of 56

Lock Releases

The BSD-DIG door controller supports both fail-secure and fail-safe lock releases including

magnetic locks of up to 1A rating at 12V DC. Suitable transient voltage protection must be

fitted across any Maglock or lock release (Some Maglocks have protection inbuilt).

If a voltage free output is required for an automatic gate trigger, or connection to another

system, an additional 12V DC relay will be needed, e.g. model 89.

Whether the lock is released from the phone, the Trades button or Exit button the door will

unlock for a pre-programmed time (adjustable 1-99 seconds, default 3 seconds).

Various lock releases can be supplied for standard timber frame doors, please contact your

sales representative for advice.

Exit button (Egress)

An input is provided for an exit button, which can be installed on the inside of the door and

allow residents to exit freely. Momentary operation of this button will operate the lock release

for the programmed lock time. The button must be of the ‘push to make’ type.

Fireman’s switch, Break glass or Emergency exit button

These should all be wired directly in series with the Fail safe lock release or Maglock itself, so

that they break the connection when operated.

Trades Facility

The Trades button allows access to the postman or other authorized tradesmen usually

during restricted hours and, if so programmed, after entering a four digit access code

(requires a TS2000-BST time clock).

Coded Access Facility

The system can allow access with two 4 digit codes. Normally 1 is allocated for use with the

Trades facility and the other is used for general resident or caretaker access. The Trades

button is used to initiate entry of either code.

Multiple Entrances

The Digibell system allows multiple entrances to be catered for (up to a maximum of 16) with

the addition of a door controller and entrance panel for each entrance and additional power

supplies as necessary.

DDA Functionality

There are a range of options for entrance panels to help meet the requirements of the

Disability Discrimination Act (DDA), including Braille characters and hearing aid induction

loop. Contact your sales representative for further details.

Gate and Block Systems

Sites with 2 or more blocks sharing a vehicle or pedestrian gate are catered for with a BSSW

Gate/Block isolator (1 per block). The blocks can then work independently but will receive

calls from the shared entrances/gates. Please refer to ‘Digibell Gate and Block Supplement.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Brak uwag

Digibell Vandal Resistant System Przewodnik Instalacji Strona 11